McCulloch MAC GBV 325 Bedienerhandbuch PDF herunterladen (Seite 5)

-- 5 --

Upper Blower

Tube

Tab

Slot

Lower Blower

Tube

Tube

clamp

bolt and

nut

4. Slide the lower blower tube onto the upper

blower tube.

5. Turn the lower blower tube clockwise until

a click is felt to secure the lower blower

tube to the upper blower tube.

NOTE: When the upper and lower blower

tubes are assembled together properly, the

arrows on both tubes will be aligned.

6. To remove the tubes, turn the bolt counter-

clockwise to loosen the tubes; remove the

tubes.

HIGH--SPEED NOZZLE ASSEMBLY

When greater air speed is desired, use the

high--speed nozzle.

1. Align the slots on the nozzle with the tabs

on the lower blower tube.

High--Speed

Nozzle

Tab

Slot

Lower Blower

Tube

2. Slide the nozzle onto the lower blower tube.

3. Turn the nozzle clockwise until a click is

felt to secure the nozzle to the lower blow-

er tube.

VACUUM ASSEMBLY

VACUUM BAG A SSEMBLY

1. Open the zipper on the vacuum bag and

insert the elbow tube.

2. Push the small end of the elbow tube

through the small opening in the bag.

Small Opening

Zipper

Opening

Elbow

Tube

Rib

NOTE: Make sure edge of the small open-

ing is flush against the flared area of the el-

bow tube, and the rib on the elbow tube is

on the bottom.

3. Close the zipper on the bag. Make sure the

zipper is closed completely .

4. Remove blower tubes from engine.

Rib

Groove

5. Insert the elbow tube into the blower outlet.

Make sure elbow tube rib is aligned with

the blower outlet groove.

6. Turnknob clockwise to secure elbow tube.

VACUUM TUBE ASSEMBLY

WARNING: Stop engine and be sure

the impeller blades have stopped turning be-

fore opening the vacuum inlet door or at-

tempting to insert or remove the vacuum or

blower tubes. The rotating blades can cause

serious injury.

1. Insert the tip of a screwdriver into the latch

area of the vacuum inlet.

Latch

Area

Blower

Outlet

Vacuum Inlet Cover

Latch

A

rea

2. Gently tilt the handle of the screwdriver to-

ward the front of the unit to release the

latch while pulling up on the vacuum inlet

cover with your other hand.

3. Hold the vacuum inlet cover open until up-

per vacuum tube is installed.

Vacuum

Inlet

Cover

Vacuum Inlet

c

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare