McCulloch MRT850 Betreibershandbuch PDF herunterladen (Seite 16)

SERVICE AND ADJUSTMENTS

CABLE CLIP

SCREW

DRIVE

CONTROL

CABLE

EXTENSION

SPRING

ENGINE

PULLEY

IDLER

PULLEY

TRANS MIS SION

PULLEY

LESS

TEN SION

5/8"

TEN SION

Fig. 24

TO REPLACE GROUND DRIVE BELT

(See Fig. 24)

• Remove belt guard as described in “TO REMOVE BELT

GUARD”.

• Remove old belt by slipping off engine pulley first then

remove from transmission pulley.

• Place new belt in groove of transmission pulley and

into engine pulley. BELT MUST BE IN GROOVE ON

TOP OF IDLER PULLEY. NOTE POSITION OF BELT

TO GUIDES.

• Check belt adjustment as described below.

• Replace belt guard.

• Reposition wheel and replace clevis pin and hairpin

clip.

GROUND DRIVE BELT ADJUSTMENT

(See Fig. 24)

For proper belt tension, the extension spring should have

about 5/8" (16 mm) stretch when tine control is in “EN-

GAGED” position. This tension can be attained as fol lows:

• Loosen cable clip screw securing the drive control

cable.

• Slide cable forward for less tension and rearward for

more tension until about 5/8" (16 mm) stretch is obtained

while the tine control is engaged.

• Tighten cable clip screw securely.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

McCulloch MRT850 Betreibershandbuch Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mini-Bodenfräsen McCulloch MRT850