McCulloch 442 Bedienerhandbuch

INSTRUCTION MANUALIMPORT ANT INFORMATION: Plea se read these in st ructi on s carefullyand make sure you underst an d th em bef o re using th is unit.

10CUTTING METHODSIMPORTANT POINTSS Check chain tension before first use and af-ter 1 minute of operation. See CHAIN TEN-SION in the ASSEMBL Y section.

11S As tree starts to fall, stop saw, put it down,and get away quickly on your planned re-treat path.S DO NOT cut down a partially fallen tree withyou

12LIMBING AND PRUNINGWARNING: Be alert for and guardagainst kickback. Do not allow the movingchain to contact any other branched or objectsat the nose

13Air FilterCylinder CoverScrewsCylinderCoverBAR MAINTENANCEIf your saw cuts to one side, has to be forcedthrough the cut, or been run with an imprope

14S Clean the unit before storing. Pay particu-lar attention to the air intake area, keepingit free of debris. Use a mild detergent andsponge to clean

15DECLARATION OF CONFORMITYrelating to 2000/14/ECEC Declaration of Conformity relating to 2000/14/ECWe, Electrolux Home Products, Inc., Texarkana, TX,

16TECHNICAL DATA SHEETDakota Mac CatEngine 441 442 442Cylinder volume, cm336 40 42Stroke, mm 32 32 32Idle speed, rpm 3,000 3,000 3,000Recommended max.

2IDENTIFICATION (WHAT IS WHAT?)PrimerBulbFuel Mix Fill CapStarter HousingBar Oil Fill CapChainFront Hand GuardFront HandleStarter RopeON/STOP SwitchMu

3IDENTIFICATION OF SYMBOLSMove ON/STOP switch tothe ON position.Slowly press primer bulb6times.Pull the starter ropesharply 5 times with yourright han

4S Do not operate a chain saw that is dam-aged, improperly adjusted, or not com-pletely and securely assembled. Alwaysreplace bar, chain, hand guard,

5lar intervals with the engine stopped, neverwith the engine running. Make sure the barclamp nuts are securely tightened after ten-sioning the chain.S

6S Tip contact in some cases may cause a light-ning fast reverse REACTION, kicking theguide bar up and back toward the operator .S Pinching the saw ch

7Clutch DrumChainBrake7. Carefully remove new chain from pack-age. Prepare the chain by checking theproper direction. Without following the il-lustrat

8NOTE: If chain brake detaches from saw ,see T O REPLACE CHAIN BRAKE section.AdjustmentKnobHandleTensioning LeverLOOSEN5. While lifting tip of guide b

9IMPORTANT POINTS TO REMEMBERWhen pulling the starter rope, do not use the fullextent of the rope as this can cause the rope tobreak. Do not let start